TDPAC and first-principles study of electronic and structural properties of a Pd-vacancy complex in undoped germanium

Pd is one of the metals suitable for inducing low-temperature crystallization in Ge. However, it is not clear how residual Pd atoms are integrated into the Ge lattice. Therefore, time-differential γ–γ perturbed angular correlations (TDPAC) technique using the ¹⁰⁰Pd(→¹⁰⁰Rh) nuclear probe produced by recoil implantation has been applied to study the hyperfine interactions of this probe in single-crystalline undoped Ge. A Pd-vacancy complex aligned along the <111> crystallographic direction with a unique interaction frequency of 8.4(5) Mrad/s has been identified. This complex was measured to have a maximum relative fraction of about 76(4)% following annealing at 350 ^°C. Further annealing at higher temperatures reduced this fraction, possibly via dissociation of the complex. Calculations suggest dissociation energy of 1.94(5) eV for the complex. DFT calculations performed in this work are in reasonable good agreement with the experimental values for the electric-field gradient of the defect complex in Ge and Si for comparison. The calculations predict a split-vacancy configuration with the Pd on a bond-centred interstitial site having a nearest-neighbour semi-vacancy on both sides (V-Pd_BI-V) in Ge and Si.     

Recent Progress in the $L_p$ Theory for Elliptic and Parabolic Equations with Discontinuous Coefficients

In this paper, we review some results over the last 10-15 years on elliptic and parabolic equations with discontinuous coefficients. We begin with an approach given by N. V. Krylov to parabolic equations in the whole space with $\rm{VMO}_x$ coefficients. We then discuss some subsequent development including elliptic and parabolic equations with coefficients which are allowed to be merely measurable in one or two space directions, weighted $L_p$estimates with Muckenhoupt ($A_p$) weights, non-local elliptic and parabolic equations, as well as fully nonlinear elliptic and parabolic equations.     

室温铁磁性Sr3YCo4O10.5+δ多晶有序化的烧结工艺及电磁性能

采用固相反应法制备了不同烧结温度(950~1 180 ℃)、烧结时间、烧结次数共7种工艺的Sr₃YCo₄O_10.5+δ多晶块材,通过热分析、XRD、SEM确定了有序化相变和最佳烧结工艺(1 180 ℃/24 h+1 180 ℃/24 h),并研究了多晶的电磁性能。结果表明,964 ℃完全晶化的四方相Sr₃YCo₄O_10.5在1 042 ℃吸氧(δ)完成有序化,生成Sr₃YCo₄O_10.5+δ,而1 100 ℃和1 180 ℃烧结的样品均出现(103)、(215)超结构峰,验证了其结构的有序性。块材均呈半导体电输运行为,二次烧结晶格完整性提高,晶粒长大,300 K时电阻率仅为0.06 Ω·cm,居里温度(T_c)~335 K,零场冷曲线(ZFC)上的Hopkinson峰源于低温时被冻结的磁矩随温度升高转向磁场方向,磁化强度在298 K达到最大,随后受热扰动的影响减小。室温铁磁性源于有序结构导致的中自旋或高自旋态Co³⁺的e_g轨道有序。     

Decay rate for viscoelastic wave equation of variable coefficients with delay and dynamic boundary conditions

In this paper, we consider a viscoelastic wave equation of variable coefficients in the presence of past history with nonlinear damping and delay in the internal feedback and dynamic boundary conditions. Under suitable assumptions, we establish an explicit and general decay rate result without imposing restrictive assumption on the behavior of the relaxation function at infinity by Riemannian geometry method and Lyapunov functional method.     

固体力学有限元体系的结构拓扑变化理论

本文是文[1]的继续.文[1]提出了杆件系统的结构拓扑变化理论和拓扑变化法本文将这一理论和方法推进到连续体有限元体系;且在此基础上揭示出有限元体系的一个新性质,称为基本位移之梯度的正交性定理,从而给出一套设计敏度的显式表达式,可直接用于计算.     

Numerical integration of ordinary differential equations on manifolds

Summary This paper is concerned with the problem of developing numerical integration algorithms for differential equations that, when viewed as equations in some Euclidean space, naturally evolve on some embedded submanifold. It is desired to construct algorithms whose iterates also evolve on the same manifold. These algorithms can therefore be viewed as integrating ordinary differential equations on manifolds. The basic method “decouples” the computation of flows on the submanifold from the numerical integration process. It is shown that two classes of single-step and multistep algorithms can be posed and analyzed theoretically, using the concept of “freezing” the coefficients of differential operators obtained from the defining vector field. Explicit third-order algorithms are derived, with additional equations augmenting those of their classical counterparts, obtained from “obstructions” defined by nonvanishing Lie brackets.     

二氧化钒薄膜的低温制备及其性能研究

针对VO₂薄膜在微测辐射热计上的应用，采用射频反应溅射法，在室温下制备氧化钒薄膜；研究了氧分压对薄膜沉积速率、电学性质及成分的影响.通过调节氧分压，先获得成分接近VO₂的非晶化薄膜，再在400℃空气中氧化退火，便可制得高电阻温度系数，低电阻率的VO₂薄膜，电阻温度系数约为-4%/℃，薄膜方块电阻为R_□为100—300kΩ；薄膜在室温下沉积，400℃下退火的制备方法与微机电加工(micro electromechanic 关键词： 二氧化钒 电阻温度系数 氧分压 射频反应溅射法     

《光谱学与光谱分析》2007年征订启事

The authors achieved the temporal coherent control in an Er^3＋ doped telluride glass, one kind of disordered solids. The upconversion at 670 nm was modulated and the dephasing time was simulated as 300 fs. Moreover, the photon echo signal gave the dephasing time due to the phonon interaction. The agreement between the two data indicates that the interaction between the wavepacket and the phonon leads to the fast disappearance of wavepackets interference, which is helpful for the tech- nique to be applied to the disordered solids.     

On the Boltzmann Equation for Fermi–Dirac Particles with Very Soft Potentials: Averaging Compactness of Weak Solutions

The paper considers macroscopic behavior of a Fermi–Dirac particle system. We prove the L ¹-compactness of velocity averages of weak solutions of the Boltzmann equation for Fermi–Dirac particles in a periodic box with the collision kernel b(cos θ)|ρ−ρ _*|^γ, which corresponds to very soft potentials: −5 < γ ≤ −3 with a weak angular cutoff: ∫₀ ^π b(cos θ)sin ³θ dθ < ∞. Our proof for the averaging compactness is based on the entropy inequality, Hausdorff–Young inequality, the L ^∞-bounds of the solutions, and a specific property of the value-range of the exponent γ. Once such an averaging compactness is proven, the proof of the existence of weak solutions will be relatively easy.     

Extrusion of pastes with a piston extruder for the determination of the local solid and fluid concentration, the local porosity and saturation and displacement profiles by means of NMR imaging

 Nuclear Magnetic Resonance (NMR) was used to investigate the extrusion behaviour of PTFE pastes in a ram extruder. By means of ¹H-NMR imaging (MRI) it is possible to determine the local proton density and therefore, the local fluid concentration. The ¹⁹F-MRI provides the local solid concentration. Thus the local saturation and the local porosity can be calculated with the information of the local fluid and solid concentration. Furthermore displacement profiles can be derived from NMR images by means of correlation techniques without any preparation or marking of the pastes. Received: 8 May 2000   Accepted: 1 May 2001